Husqvarna Automower charging station is solid red. What does it mean?
Short answer: A solid red light on the charging station means there's a defective circuit board in the charging station or the power supply is incorrect. Husqvarna lists two owner checks: the low-voltage cable and a 30-second power restart. Beyond that, it's a job for a service technician.
Applies to: Husqvarna Automower charging stations.
What Husqvarna says
"A solid red light on the charging station of your Automower® robotic lawn mower means that there is a defective circuit board in the charging station or the power supply is incorrect."
Source: Husqvarna Support, "What does a solid red light on the Automower® charging station mean?" (KA-01719). Official page
Steps Husqvarna recommends
- Check the low-voltage cable. Make sure it isn't damaged. If it is, replace it.
- Restart the power. Disconnect the power supply from the charging station for 30 seconds, then reconnect it. (Husqvarna, "No loop signal on Automower®—causes and solutions," solid red section, official page.)
When to stop and contact support
If the cable isn't damaged and the light stays red after the restart, Husqvarna says an authorised service technician needs to investigate the fault. Contact your local Husqvarna dealer. Don't open the charging station yourself.
Related questions
Checked against Husqvarna's official support page: November 18, 2026.
This is a convenience reference based on the manufacturer's official support information. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by Husqvarna. Automower® is a registered trademark of Husqvarna AB. Incorrect procedures can damage equipment or create safety hazards.