Tool Decoder

What the lights and error codes on your tools mean, from the manufacturer's manual.

Husqvarna Automower flashing blue light and "No loop signal": what should I check first?

Short answer: A flashing blue light on the charging station means it can't make a complete loop signal through the boundary wire. Husqvarna says the usual cause is a broken wire or a faulty connection. Check the wire connections at the charging station first.

Applies to: Husqvarna Automower robotic mowers. Other LED colors on the charging station mean different things.

What Husqvarna says

"A flashing blue light indicates that the charging station cannot establish a complete loop signal."

Source: Husqvarna Support, "No loop signal on Automower®—causes and solutions," section "Charging station LED flashes blue—wire or connection issue" (updated June 8, 2026). Official page

Steps Husqvarna recommends

  1. Check the connection at the charging station. Make sure the boundary wire ends are fully inserted and the contacts are clean and secure.
  2. Look for a broken or damaged wire. Wire can be cut or damaged by gardening, weather or animals. Husqvarna has a separate guide for finding and repairing a wire break.
  3. Check with a multimeter. Disconnect the boundary wire from the charging station and measure the resistance across the two wire ends. Husqvarna's guideline is about 0.8 ohm per 100 m of wire (about 1.6 ohm for 200 m). Several hundred ohm points to a break.

If you need to repair the wire

As an Amazon Associate I earn from qualifying purchases.

Husqvarna says to replace a damaged section with new loop wire. These are Husqvarna's own parts.

When to stop and contact a dealer

If the resistance is in the expected range and the connections are secure but the light still flashes blue, Husqvarna says the charging station's circuit board may be the problem. Contact a Husqvarna dealer.

Related questions

Checked against Husqvarna's support page: November 18, 2026.

This is a convenience reference based on the manufacturer's official support information. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by Husqvarna. Automower® is a registered trademark of Husqvarna AB. Incorrect procedures can damage equipment or create safety hazards.