Why is my EGO battery flashing red and not charging?
Short answer: On the EGO 56V standard charger (CH2100), a flashing red light means the battery pack or the charger is defective, or there's a bad connection between them. A solid red light means something different: the battery is too hot or too cold.
Applies to: EGO 56V Standard Charger CH2100 / CH2100-FC. Other EGO chargers use a different LED for this signal. Check your charger's model number.
What the manual says
"If the charger detects a problem, the red LED will begin flashing and the green LED will go off."
Source: EGO, Operator's Manual, 56-Volt Charger CH2100/CH2100-FC, "Defective Battery Pack or Charger," p. 15. Official PDF
Steps EGO recommends
- Remove the battery pack and put it back in the charger.
- Try charging a different EGO battery pack on the same charger.
- Unplug the charger, wait until the red LED goes out, then plug it back into the power supply.
Source: same manual, Troubleshooting table, p. 17.
If a different battery pack charges normally, the first battery pack is the problem. If a different battery pack also shows "defective," the charger may be the problem.
If the steps point to a bad battery or charger
As an Amazon Associate I earn from qualifying purchases.
Only replace a part after the steps above show which one is defective. These are EGO's own (OEM) parts.
- EGO POWER+ 56V 5.0Ah Battery (BA2800T): EGO's own 5.0Ah battery, listed as compatible in the CH2100 manual.
- EGO POWER+ 56V Standard Charger (CH2100): EGO's own charger, the same model this page covers.
When to stop and contact EGO
If the red light keeps flashing after these steps, stop and contact EGO Customer Service at 1-855-EGO-5656 or egopowerplus.com.
Related questions
- EGO charger shows a solid red light: what does it mean?
- My EGO battery charges on one charger but not another: which one is bad?
Checked against the manual: November 18, 2026.
This is a convenience reference based on the manufacturer's manual. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by EGO or Chervon. Incorrect procedures can damage equipment or create safety hazards.