EGO charger shows a solid red light: what does it mean?
Short answer: On the EGO 56V standard charger (CH2100), a solid red light means the battery pack is too hot or too cold to charge. Let it warm up or cool down. The charger starts charging by itself once the battery is between 37°F and 135°F (3°C–57°C).
Applies to: EGO 56V Standard Charger CH2100 / CH2100-FC. A flashing red light means something else (see below).
What the manual says
"If the battery pack is out of the normal temperature range, the red LED will shine and the green LED will go off."
Source: EGO, Operator's Manual, 56-Volt Charger CH2100/CH2100-FC, "Charging a Hot or Cold Battery Pack," p. 15. Official PDF
Steps EGO recommends
- Let the battery pack reach normal temperature.
- Charging begins on its own when the battery is back between 37°F (3°C) and 135°F (57°C).
Source: same manual, Troubleshooting table, p. 17.
If that didn't work: what owners on Reddit say
Not from the EGO manual. These are tips recommended by users on r/egopowerplus. They may help, but EGO doesn't list them. Try them at your own risk, and stop if anything gets hot, smells or sparks.
- Bring a cold battery inside to charge. Users on r/egopowerplus recommend bringing packs left in a cold garage indoors and charging them inside the house. One owner said about 25 minutes on the charger indoors brought theirs back. Never heat a battery to speed this up. (Reddit thread, Dec 2022)
When to stop and contact EGO
If the light stays solid red after the battery is at normal temperature, stop and contact EGO Customer Service at 1-855-EGO-5656 or egopowerplus.com.
Related questions
- Why is my EGO battery flashing red and not charging?
- My EGO battery charges on one charger but not another: which one is bad?
Checked against the manual: November 18, 2026.
This is a convenience reference based on the manufacturer's manual. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by EGO or Chervon. Incorrect procedures can damage equipment or create safety hazards.