My Husqvarna Automower won't charge, or docks and leaves right away. What should I check?
Short answer: Husqvarna says to start with three checks: the charging station light, the docking contact (the mower sitting squarely with clean charging plates), and the battery temperature. After winter storage, the battery may need several hours on the station.
Applies to: Husqvarna Automower robotic mowers.
What Husqvarna says
"Make sure the robotic lawn mower sits squarely in the charging station with the charging plates making full contact."
Source: Husqvarna Support, "Automower® won't charge or shows empty battery error" (KA-70405), "What to check first." Official page
Steps Husqvarna recommends
- Check the charging station light. If it's off, see the station light off page. If it's solid red, see the solid red page.
- Check the docking contact. Make sure the mower sits squarely with the charging plates making full contact. Clear leaves, clippings and debris from the docking area and from the charging contacts on both the mower and the station.
- Check the battery temperature. Husqvarna says the mower won't charge if the battery temperature is outside the accepted range.
- After winter storage: if it was stored without a full charge, bring the mower indoors, place it on the charging station and leave it for several hours.
When to stop and contact support
If it still won't charge after these checks, contact your local Husqvarna dealer.
Related questions
- Charging station light is off
- Automower "Empty battery" error
- Husqvarna Automower flashing blue light and "No loop signal": what should I check first?
- Husqvarna Automower charging station is flashing yellow. What does it mean?
Checked against Husqvarna's official support page: November 18, 2026.
This is a convenience reference based on the manufacturer's official support information. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by Husqvarna. Automower® is a registered trademark of Husqvarna AB. Incorrect procedures can damage equipment or create safety hazards.