Tool Decoder

What the lights and error codes on your tools mean, from the manufacturer's manual.

My Husqvarna Automower charging station light is off. What should I check?

Short answer: If the charging station light doesn't light up, Husqvarna says it may be a problem with the cable or the power supply. Check the outlet, then the low voltage cable and its connections.

Applies to: Husqvarna Automower charging stations. You may also see "No loop signal" or "Charging station blocked" on the mower.

What Husqvarna says

"If the light on the charging station for the Automower® robotic lawnmower doesn't light up, this may indicate issues with the cable or power supply."

Source: Husqvarna Support, "Why is the light on the Automower® charging station off?" (KA-70191). Official page

Steps Husqvarna recommends

  1. Test the outlet. Plug in something you know works, like a lamp.
  2. Reconnect the low voltage cable. Disconnect and reconnect both ends.
  3. Check the low voltage cable for damage along its length and at both ends.
  4. Test the cable (most models). Plug the power adapter straight into the station's power inlet. If the light comes on, the cable is most likely damaged. Husqvarna says this test doesn't work on the 440, 440 with Automower Connect kit, 450X NERA, 450X NERA with EPOS Plugin, 450X and 435X AWD.
  5. Check it's the right cable. The low voltage cable isn't the same for every model.

When to stop and contact support

If none of this fixes it, or the station stopped working after a thunderstorm, Husqvarna says to contact your local Husqvarna dealer.

Related questions

Checked against Husqvarna's official support page: November 18, 2026.

This is a convenience reference based on the manufacturer's official support information. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by Husqvarna. Automower® is a registered trademark of Husqvarna AB. Incorrect procedures can damage equipment or create safety hazards.